The step-by-step process of manufacturing a replica of Nikola Tesla’s Single Wire Electric Lamp.
As with other high vacuum tubes recreated under Tesla’s name, the next step was to observe the production of speciality rays which Tesla dubbed as Shadowgraphs, since the fogging and exposures created on photographic plates resembled shadows. These results were observed by […]
Through the use of a handmade Tesla Carbon Button Lamp, the effect of plasma rotation as noted by Tesla in his 1892 book and lecture, “Experiments With Alternate Currents of High Potential and High Frequency,” was successfully replicated. This is likely one […]
In conjunction with work being carried out on the development of the seismic rack, attention has been temporarily directed towards high frequency and vacuum. A usefully donated high frequency disruptive discharge device known as a Diathermy Apparatus was refurbished, and brought to […]
Prior to the 2022 Energy Science & Technology Conference, some interesting lead way was made in the course of re-developing the Tesla Brush Bulb. It was borne in mind that the brush formation which Tesla speaks of must have had influence with […]
As in the previous post where an evacuated sphere possessing no special physical characteristics was shown displaying physical phenomena, the following shows work carried out with a Brush Bulb. In this circumstance, this Brush Bulb has been evacuated via a turbo-molecular pump […]
References made in this post can be seen in the latest High Frequency Illumination Lecture from the 2022 Energy Science & Technology Conference. As a new turbo molecular pump has become available, certain high vacuum experiments have been carried out to investigate […]
Below are photos of a replicated Tesla brush bulb at various RF power levels. The bulb is directly connected to the high tension winding of a high power RF source, ultimately connected to only the carbon button. This bulb shown, as it […]
As the completion of an ultra high vacuum system is now in use, the final development of the Tesla Bruh Bulb has now been achieved. This is to say that with the tedious nature of the very construction of the bulbs, a […]
As of now, parts have been received for a diffusion vacuum pump which is capable of pulling a vacuum to 0.000000001 Torr (roughly the same pressure experienced in Low Earth Orbit, LEO). This will be the driving force behind all brush bulb […]